SPD Tech Circuit Protection Devices & Solutions
中文

TDK expands its MOV & surge-protection portfolio (e3S / i92S)

· 5 min
TDKMOVsurge protectione3Si92Sthermal disconnect

TDK is growing its MOV array and thermal-disconnect MOV lines for PV and industrial use, turning "surge clamping + auto thermal disconnect on fault" into a modular solution.

The news

TDK Electronics has been expanding its surge-protection device lines around PV inverters, grid-tie cabinets and industrial power distribution:

  • MOV arrays (i92S / i93S): multi-MOV integrated modules for PV multi-phase and multi-MPPT use, cutting board area; paired with "array + fuse" cascades.
  • Thermal-disconnect MOVs (with third indication lead): beyond a plain MOV, a version that opens on thermal fault, avoiding a plain MOV's end-of-life short failure — the preferred form for smart meters and PV grid-tie.
  • SMD TVS + MOV combos: fast TVS clamp on the small-signal side + high-current MOV on the power side, integrated on-board.

What it means for your selection

  • For a PV grid-tie cabinet or smart meter, ask for the thermal-disconnect MOV (with the third lead), not a bare MOV: it auto-opens on fault, cutting secondary-short risk and making it easier to pass the "short-circuit endurance" criterion.
  • Multi-outlet MOV arrays save area vs. single MOVs and make per-outlet indication easier — good for maintainable distribution products.
  • When specifying, align the MOV's MCOV / VPR / In with the upstream T1/T2-stage SPD coordination; don't pick the MOV in isolation.