Application Solutions
Circuit-protection solutions grouped by implementation path — power & system protection, renewable & storage protection, signal & interface protection, board & automotive protection — covering industrial, automotive, data-center, consumer, PV/ESS and building scenarios.
Smart-Meter Surge Design: MOVTP Selection & Coordination
Smart meters connect straight to the mains, where lightning and inductive load-switching create transient overvoltages. A MOV with thermal-disconnect (MOVTP) is the common "clamp + auto-disconnect at end-of-life" choice — this piece walks through device physics, specs and coordination.
Protection of Buildings
The complete chain from roof interception to final-stage devices — SPD graded cascade as the backbone, with end-stage TVS/ESD fine clamping and PPTC/Fuse overcurrent backup, and why LPZ boundaries must match reality.
Residential and Smart Home Protection
Residential lightning and surge damage concentrates in a few spots — broadband modems, power adapters, outdoor units, smart home gateways — addressed with a combo of SPD, end-stage TVS/ESD and port PPTC.
Energy Storage and DC Bus Protection
Battery racks, converters and DC busbars — high energy density and HVDC bring two hard problems: switching overvoltage and DC arcing; protect with DC SPD, fuses and insulation monitoring.
Lightning Protection for Photovoltaic Systems
PV is among the most strike-prone installations — module frames, rails, backplanes and DC insulation are all failure points; protect with DC-side SPD (with DC fuses) plus signal-side TVS/ESD.
Consumer Electronics
Phones, laptops, appliances and USB-C fast charging face port ESD, battery overcurrent and mains entry surge; a light yet complete scheme uses USB-C-line TVS/ESD, battery PPTC, power-entry TMOV and signal ESD.
Communication and Data Centre Protection
Separating signal-side and power-side protection, room equipotential bonding, and why a surge-protected socket is far from enough — a system view of power SPD + signal TVS/ESD + overcurrent PPTC.
Automotive Electronics
12/24 V battery systems, CAN/LIN/automotive Ethernet and ECUs face load dump, battery reverse, and severe ESD; automotive-grade protection uses high-power TVS, bus ESD arrays, PPTC/fuse at the power entry and reverse-polarity protection.
Industrial Control
PLCs, VSDs, sensors and field buses face inductive load transients, long-line induction, motor-start inrush and field ESD; a complete scheme uses TMOV/SPD at the power entry, TVS/ESD on signals, MOV arc-suppression on contacts and PPTC/fuse for overcurrent.
