SPD Tech Circuit Protection Devices & Solutions
中文

Automotive Electronics

· 10 min
AutomotiveLoad dumpCANAEC-Q

12/24 V battery systems, CAN/LIN/automotive Ethernet and ECUs face load dump, battery reverse, and severe ESD; automotive-grade protection uses high-power TVS, bus ESD arrays, PPTC/fuse at the power entry and reverse-polarity protection.

What Makes Automotive Special

Automotive circuit protection is far harsher than consumer:

  • Load dump: when the battery disconnects, the alternator can produce a tens-of-volts spike lasting hundreds of ms (ISO 7637-2 / ISO 16750).
  • Reverse / mis-connection: service and jump-start can reverse polarity.
  • Severe ESD: humans touch in-vehicle ports directly, requiring ISO 10605 ±15 kV or higher.
  • Wide temperature and life: −40 ℃ to +125 ℃ continuously, 15-year life.
Location Main threat Recommended
12/24 V battery bus load dump high-power TVS (load-dump type, meets ISO 16750 energy)
ECU power entry reverse/overvoltage/overcurrent reverse protection + TVS + PPTC/fuse
CAN/LIN bus ESD / common-mode ESD/TVS array (automotive)
automotive Ethernet/USB ESD / high-speed ultra-low-cap ESD array (<0.5 pF)
motors / actuators stall / short PPTC + fuse

Selection Points

  1. Load dump needs a dedicated high-power TVS that meets the ISO 16750 energy and voltage; a generic TVS will be destroyed.
  2. Bus protection uses automotive-grade ESD arrays validated to AEC-Q101 (discretes) or the broader AEC-Q program.
  3. Grade the power entry: reverse protection (diode/MOS) + TVS (overvoltage) + PPTC/fuse (overcurrent), all three present.
  4. Low capacitance on high-speed: automotive Ethernet/USB must be < 0.5 pF or communication fails.

Key reminder

Automotive parts must pass the AEC-Q series (e.g. AEC-Q101 for TVS, AEC-Q200 for passives). Putting consumer-grade parts in a vehicle is a major reliability hazard.

Standards

  • ISO 10605 (ESD)
  • ISO 7637-2 / ISO 16750 (electrical disturbance and transients)
  • AEC-Q101 / AEC-Q200 (automotive-qualified components)

Next