SPD Tech Circuit Protection Devices & Solutions
中文

Industrial Control

· 9 min
IndustrialPLCVSDField bus

PLCs, VSDs, sensors and field buses face inductive load transients, long-line induction, motor-start inrush and field ESD; a complete scheme uses TMOV/SPD at the power entry, TVS/ESD on signals, MOV arc-suppression on contacts and PPTC/fuse for overcurrent.

Where Overvoltage Comes From in Industry

The industrial environment is among the hardest for circuit protection:

  • Inductive load transients: relays, contactors, solenoid valves and motors generate hundreds of volts to kV spikes at switch-off.
  • Long-line induction: field-bus and sensor wires run tens of meters and pick up lightning and switching noise.
  • Motor-start inrush: VSDs and servo drives have large turn-on surges.
  • Field ESD: maintenance plugging and human contact at interfaces.
Location Main threat Recommended
AC power entry lightning / switching TMOV (fire-safe), Type 2 SPD
DC 24 V control inductive spikes TVS (24 V class)
relay / contactor contacts arc suppression MOV across contacts
field bus (RS-485/Profibus) induction + ESD TVS / ESD array
motor / valve drive start inrush, stall PPTC (overcurrent) + fuse (short)
comm ports ESD / surge ESD array + common-mode GDT

Selection Points

  1. Prefer TMOV over bare MOV at the power entry: industrial gear is often unattended, so fire safety is mandatory (see TMOV).
  2. Low-capacitance TVS/ESD on signal lines: field buses are not high-speed but long lines have large distributed capacitance; too much capacitance distorts the waveform.
  3. MOV across contacts absorbs relay back-EMF and extends contact life.
  4. Grade the overcurrent: PPTC for intermittent (stall), fuse for catastrophic short.

Note

Treat power + signal + overcurrent protection as one system, not independent per-port choices. A surge on one port can couple to neighbors through the common ground.

Standards and Tests

  • IEC 61131 (programmable controllers)
  • IEC 61000-4 series (ESD 4-2, surge 4-5, EFT 4-4)
  • IEC 61800 (adjustable-speed drives)

Next